Skip to content
SJE SignalMaster®10ft Mechanically-Activated, Narrow-Angle Control Switch
$40.00 - $40.00
$40.00
$40.00 - $40.00
$40.00
  7 Reviews

SJE SignalMaster®10ft Mechanically-Activated, Narrow-Angle Control Switch

SJE Rhombus
The SJE SignalMaster® 1011678 uses a mechanical action to make a stable connection within the switch. Thus, the chattering seen in mercury float switches is avoided with this float switch. Additionally, there is no chance of mercury contaminating the water source, because mercury is not used to make the connections within this switch.

Ordering Online?

We ship daily: checking..
free shipping
SKU SJE-NOF-S10N007
  • Key Features
  • Specs
  • Warranty

  • The 1011678 is a narrow angle float switch. That means that the float switch does not have to raise up very high to trigger the switch.

    This switch is most often entrusted to control an alarm circuit, because this switch is rated for a relatively low number of amps. The fact that this is a narrow angle float switch means that it would trigger the alarm before a wide-angle float switch. Meaning, you will be notified sooner if a problem is detected.

    The 1011678 is a normally open float switch. This makes it ideal to detect a high-water level. Whenever the water level is low, the float switch will be open. Whenever the water level is too high, the switch will close and indicate to the control panel that the alarm should be activated.

    Specifications

    • Switch Type: Normally Open Mechanical Switch
    • Maximum amps for running current: 5 amps
    • Cord Length: 10 ft.





Questions & Answers

Have a Question?

Ask a Question

  • Is this only for the alarm or can they be used to turn on and off the grinder pump?

    This is a control-duty switch (meaning it has a low-amp rating, intended for sending signals to a control panel), so it would depend on what type of control panel you have. It won't be able to directly control the power to the grinder pump.
    However, if your control panel uses relays or contactors to turn the pump on/off, then this switch would be able to send the signal to the panel, which could then trigger the contactor to turn on the grinder pump.